Revision to Root
== Introduction == | |
- | Welcome to the Wiki for the Duet 2 (Wifi, Ethernet Maestro), Duet 0.8.5, and the Duet 0.6 - a family of control boards for 3D printers and other similar robots. These control boards are based on a 32-bit ARM processor, running [[Firmware_Overview|RepRapFirmware]]. The Duet family can all be controlled through a [[Duet_Web_Control_Manual|web interface]], but they also support a touchscreen called the [[PanelDue]]. They all have a connector for an expansion board containing additional stepper drivers and I/O circuitry - the |
+ | Welcome to the Wiki for the Duet 2 (Wifi, Ethernet Maestro), Duet 0.8.5, and the Duet 0.6 - a family of control boards for 3D printers and other similar robots. These control boards are based on a 32-bit ARM processor, running [[Firmware_Overview|RepRapFirmware]]. The Duet family can all be controlled through a [[Duet_Web_Control_Manual|web interface]], but they also support a touchscreen called the [[PanelDue]]. They all have a connector for an expansion board containing additional stepper drivers and I/O circuitry - the Duex 2 and Duex 5 for the Duet 2 (WiFi and Ethernet), and the legacy DueX4 for the Duet 0.6 and 0.8.5, and |
== START HERE == | |
* [[Connecting an Emergency Stop]] | |
* [[Connecting and configuring filament-out sensors]] | |
- | * [[Duex2_and_Duex5_Features| |
+ | * [[Duex2_and_Duex5_Features|Duex 2 and Duex 5 expansion boards]] |
* [[Using external stepper motor drivers]] | |
* [[Adding additional output ports]] |
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.