Set reduced acceleration for special move types
Back to the Gcode Dictionary
M201.1: Set reduced acceleration for special move types
- Xnnn Acceleration for X axis in units/s2
- Ynnn Acceleration for Y axis in units/s2
- Znnn Acceleration for Z axis in units/s2
- Ennn:nnn... Acceleration for the extruders in units/s2
M201.1 X500 Y500 Z20 E500:500
Set the acceleration that axes should use for special types of move that should be done using reduced acceleration.
These values are used for probing moves (because some types of Z probe can be triggered by high acceleration at the start of the move) and for moves that involve stall detection endstops (because high acceleration can bring the motor close to stalling). If a single E value is provided, that value is applied to all extruders. The values must be provided in mm/sec2 even if G20 has been used to set units to inches. M201.1 without parameters reports the current settings.