M190
Back to the Gcode Dictionary
M190: Wait for bed temperature to reach target temp
Parameters
- Snnn minimum target temperature, waits while heating
- Pnnn Bed index1
- Rnnn accurate target temperature, waits while heating and cooling
Example
- M190 S60
Set the temperature of the bed to 60C and wait for the temperature to be reached.
Note: M190 will not wait for temperatures below 40c because in many cases they may never be reached due to ambient temps. So if you want to wait for a bed to cool, use 41c or higher.
1 Only supported in RepRapFirmware 1.20 and later.
0 Comments