Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at https://docs.duet3d.com/
Help

Revision to Using servos and controlling unused IO pins

David Crocker

| E5_STOP
| 19
+|--
+| 64
+| ENC_SW
+| ENC_SW on CONN_SD connector
+| 7 on CONN_SD connector
+|--
+| 65
+| Z_PROBE_MOD
+| MOD on Z-probe connector
+| 3 on Z-probe connector
}
+
+Logical pins 64 and 65 are supported in firmware 2.01 and later only. Note that the Z_PROB_MOD pin is driven automatically when some Z probe modes are selected.
=== Duet 0.6 and 0.8.5 ===

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes