Revision to Using servos and controlling unused IO pins
+ | |
---|---|
+ | == Introduction == |
+ | |
+ | The Gcodes [[Gcode#Section_M42_Switch_I_O_pin|M42 Switch I/O pin]] and [[Gcode#Section_M280_Set_servo_position|M280 set servo position]] allow direct control of some pins, or re-purposing of those pins to control PWM hobby servos |
== Important note on connecting servos == |
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.