https://docs.duet3d.com/
Help

Revision to Using mesh bed compensation

Tony

== Summary of gcode commands related to mesh bed compensation ==
-* '''G29''' or '''G29 S0''' Probe the bed and save height map to file
+* '''[[Gcode#Section_G29_Detailed_Z_Probe|G29]]''' or '''G29 S0''' Probe the bed and save height map to file
* '''G29 S1''' Load height map from file
* '''G29 S2''' Clear height map
-* '''G30''' Probe the bed at a single point (can be used to measure Z probe trigger height)
-* '''G31''' Set Z probe trigger height, threshold and offsets from the print head reference point
-* '''G32''' Run sys/bed.g file. You can put commands in bed.g to perform mesh bed levelling, e.g. M401 followed by G29 S0 followed by M402.
-* '''M374''' Save height map to file
-* '''M375''' Load height map from file (same as G29 S1)
-* '''M376''' Set bed compensation taper height
-* '''M401''' Deploy Z probe (runs sys/deployprobe.g file)
-* '''M402''' Retract Z probe (runs sys/retractprobe.g file)
-* '''M557''' Define the probing grid
-* '''M558''' Set Z probe type, dive height, probing speed, travel speed between probe points, and probe recovery time
-* '''M561''' Clear height map (same as G29 S2)
+* '''[[Gcode#Section_G30_Single_Z_Probe|G30]]''' Probe the bed at a single point (can be used to measure Z probe trigger height)
+* '''[[Gcode#Section_G31_Set_or_Report_Current_Probe_status|G31]]''' Set Z probe trigger height, threshold and offsets from the print head reference point
+* '''[[Gcode#Section_G32_Probe_Z_and_calculate_Z_plane|G32]]''' Run sys/bed.g file. You can put commands in bed.g to perform mesh bed levelling, e.g. M401 followed by G29 S0 followed by M402.
+* '''[[Gcode#Section_M374_Save_height_map|M374]]''' Save height map to file
+* '''[[Gcode#Section_M375_Load_height_map|M375]]''' Load height map from file (same as G29 S1)
+* '''[[Gcode#Section_M376_Set_bed_compensation_taper|M376]]''' Set bed compensation taper height
+* '''[[Gcode#Section_M401_Deploy_z_probe|M401]]''' Deploy Z probe (runs sys/deployprobe.g file)
+* '''[[Gcode#Section_M402_Retract_z_probe|M402]]''' Retract Z probe (runs sys/retractprobe.g file)
+* '''[[Gcode#Section_M557_Set_Z_probe_point_or_define_probing_grid|M557]]''' Define the probing grid
+* '''[[Gcode#Section_M558_Set_Z_probe_type|M558]]''' Set Z probe type, dive height, probing speed, travel speed between probe points, and probe recovery time
+* '''[[Gcode#Section_M561_Set_Identity_Transform|M561]]''' Clear height map (same as G29 S2)
See the [[Gcode|G-code page]] for details of these commands.

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes