Skip to main content

Site Navigation

Your Account

Choose Language

Help

Revision to Tuning the heater temperature control

Stuart Wimbush

After you have run auto tuning and checked that the heater control is working well, run M500 to save the heater parameters in config-override.g (this is supported in firmware 1.17 and later). Alternatively, construct a M307 command with the model parameters and add it to config.g. For example, if after tuning you run M307 H0 and see this:
 
[code]M307 H0[/code]
code]
M307 H0
[code]M307 H0[/code]
code]
M307 H0
Heater 0 model: gain 199.0, time constant 962.6, dead time 4.5, in use: yes
[/code]
 
then you should add the following to config.g to preserve this model:

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes