Skip to main content

Site Navigation

Your Account

Choose Language

Help

Revision to Test and calibrate the Z probe

Jason Znack

 
# Make sure the dynamic test is successful (Z probe stops when it senses the bed) before doing this.
# Ensure that the Z offset in G1G31 in config.g is set to 0, these steps will be used to measure this actual offset. (send G31 Z0 to set it to 0).
# Ensure that the Z offset in G1G31 in config.g is set to 0, these steps will be used to measure this actual offset. (send G31 Z0 to set it to 0).
# Use the X and Y jog buttons to position the nozzle over the centre of the bed
# Jog the nozzle down until it is just touching the bed or just gripping a sheet of paper.

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes