Skip to main content

Site Navigation

Your Account

Choose Language

Help

Revision to Test and calibrate the Z probe

Tony

# Repeat from step 5 two or three times to make sure that the trigger height is consistent.
# In Duet Web Control, go to Settings -> System Editor and edit the config.g file. Set the Z parameter in the G31 command t the trigger height that was reported. Save the file.
 
== More information on Z Probes ==
 
* Help with [[Choosing a Z probe]]
* Information on [[Connecting a Z probe]]

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes