Skip to main content

Site Navigation

Your Account

Choose Language


Revision to Setting up to resume a print after a power failure

Christian Hammacher

'''These instructions relate to RepRapFirmware 1.20 and later (including RRF 2.x and 3.x).''' The auto-save facility was first introduced in version 1.19, however improvements in 1.20 necessitated changes to the configuration mechanism.
+''This is not supported in SBC mode yet (see [link||here]).''
== Overview ==

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes