Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Revision to Setting up to resume a print after a power failure

David Crocker

In this example, the power fail procedure is execute if VIN drops below 21.0V. It does the following:
-* Set X and Y motors to zero current (M913 X0 Y0). This is to make the power last longer. Don't do this on a delta printer.
+* Set X and Y motors to zero current (M913 X0 Y0). This is to make the power last longer. Don't do this on a delta printer. Important: use M913, not M906. This is because M906 won't execute until all queued moves have been completed, whereas M913 will execute immediately.
* Set relative movement mode (G91)
* Set relative extrusion mode (M83)

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes