Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Site Navigation

Your Account

Choose Language

Revision to G-Codes not implemented


* M800: Fire start print procedure (use start gcode in slicer)
* M801: Fire end print procedure (use end gcode in slicer)
-* M851: Set Z-Probe Offset (use G31)
* M907: Set digital trimpot motor (use M906)
* M908: Control digital trimpot directly (no requirement, use M906)

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes