Skip to main content

Site Navigation

Your Account

Choose Language

Help

Revision to Duet3dFilamentMonitor RotatingMagnetVersion

Tony

* P = filament sensor type. P3 = Duet3D filament monitor without additional filament presence detection switch, P4 = Duet3D filament monitor with switch.
* Snnn = mm of filament fed per complete rotation of the sensor wheel. May be positive or negative.
* C = endstop number (0 = X, 1 = Y, 2 = Z, 3 = E0 etc.). Endstop inputs 5-9 which are on the DueX2Duex 2 or DueX5Duex 5 expansion boards cannot be used. Endstop inputs 10-11 on the CONN_LCD connector can be used.
* C = endstop number (0 = X, 1 = Y, 2 = Z, 3 = E0 etc.). Endstop inputs 5-9 which are on the DueX2Duex 2 or DueX5Duex 5 expansion boards cannot be used. Endstop inputs 10-11 on the CONN_LCD connector can be used.
* R = relative tolerance in %, default 20%
* E = minimum extrusion length before a commanded/measured comparison is done, default 3mm

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes