Skip to main content

Site Navigation

Your Account

Choose Language


Revision to Connector and spare part numbers

David Crocker

You will need a hot air desoldering tool with a small nozzle to remove the old mosfet. Use a shield made from corrugated cardboard and Kapton tape to shield connectors and other plastic components from the hot air. The new mosfet can be soldered in place using a fine-tipped soldering iron, or by putting a little no-clean flux on the pads, placing the new mosfet on top, and using hot air again. Hot air soldering/desoldering is easier if you heat the whole board to about 100-125C on an electric hotplate.
Alternatively, use ChipQuik and a soldering iron to remove the old mosfet.
=== VSSA fuse ===

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes