Skip to main content

Site Navigation

Your Account

Choose Language

Help

Revision to Connecting and configuring filament-out sensors

Tony

=== Firmware 1.19 and later ===
 
RepRapFirmware supports a variety of different filament presence and motion optionssensors using the [[Gcode#Section_M591_Configure_filament_sensing|M591 Gcode]]:
RepRapFirmware supports a variety of different filament presence and motion optionssensors using the [[Gcode#Section_M591_Configure_filament_sensing|M591 Gcode]]:
 
Pnn Type of sensor:
* 7 = pulse-generating sensor
 
See [[Gcode#Section_M591_Configure_filament_sensing|Gcode M591the [[Gcode#Section_M591_Configure_filament_sensing|M591 Gcode]] for full configuration information.
See [[Gcode#Section_M591_Configure_filament_sensing|Gcode M591the [[Gcode#Section_M591_Configure_filament_sensing|M591 Gcode]] for full configuration information.
 
There are two beta implementations offor motion detectiondetection with direction:
There are two beta implementations offor motion detectiondetection with direction:
 
* [[Duet3dFilamentMonitor RotatingMagnetVersion|Duet3d Filament Monitor: rotating magnet version]]

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes