Revision to Connecting and configuring filament-out sensors
| === RepRapFirmware 3.2 and later === | |
| - | In RRF 3.2 and later, if you configure a filament monitor using M591, when it reports no filament RRF will try to run filament-error#.g where # is the extruder number, or failing that filament-error.g. If neither of those is found then it runs pause.g. |
| + | In RRF 3.2 and later, if you configure a filament monitor using M591, when it reports no filament RRF will try to run filament-error#.g where # is the extruder number, or failing that filament-error.g. If neither of those is found then it runs pause.g. After that the print is paused and a notification is sent advise you that there has been a filament error |
| === RepRapFirmware 1.19 and later === |
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.