Revision to Connecting and configuring filament-out sensors
+ | |
---|---|
+ | === RepRapFirmware 3.3 and later === |
+ | |
+ | In RRF3.3 if you configure a filament monitor using M591, when it reports no filament RRF will try to run filament-error#.g where # is the extruder number, or failing that filament-error.g. If neither of those is found then it runs pause.g. |
=== Firmware 1.19 and later === |
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.