Revision to Connecting and configuring fans
|The gcode command to set the fan speed is M106 Pnn Svv where nn is the fan number (default 0 if the P parameter is not present) and vv is the required speed. The speed can be expressed either in the range 0 to 1, or in the range 0 to 255. A value of 1 or less will be assumed to be in the range 0 to 1. A value of 0 corresponds to off, and a value of 1 or 255 corresponds to full speed.|
|== Allocating fans to tools ==|
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.