Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Revision to Centering the bed or setting the bed origin

David Crocker

[/code]
-Note: you would normally have Z parameters in the M208 commands too.
+Notes:
+
+1. You would normally have Z parameters in the M208 commands too.
+
+2. The M208 limits set the position immediately after the corresponding G1 S1 command completes by triggering the homing switch. However, if your homing file has a G92 command after the G1 S1 command (as is typically the case when homing to a Z-min switch), then the G92 command will override that position.
== Setting the origin on a Linear Delta or Rotary Delta printer ==

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes