Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Revision to Bed levelling using multiple independent Z motors

Jason Znack

M402 ; retract probe (omit if using bltouch)
[/code]
+
+== Note on M584 from examples above ==
+
+VERY IMPORTANT! Assigning a drive using M584 does not remove its old assignment. Therefore, if you assign a drive that defaults to being an extruder drive, you should also assign the extruder drives explicitly as in the above example. Failure to do so may result in unexpected behaviour.
+
+[[Gcode#Section_M584_Set_drive_mapping|See Gcode wiki]]

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes