Back to the Gcode Dictionary
G32: Run bed.g macro
In RRF 3.3 and later any parameters will be passed to macro file bed.g.
The firmware executes macro file bed.g. This macro normally uses G30 commands to probe the bed and then perform auto calibration of a delta printer (see Calibrating a delta printer), or perform bed levelling by moving the Z leadscrews independently, or display the manual corrections needed to the bed levelling screws.
For more detail on using G32 for automatic Delta calibration see: Calibrating a delta printer
For more detail on using G32 for automatic leveling of a cartesian or CoreXY see: Bed levelling using multiple independent Z motors
For more detail on using G32 for manual bed leveling assistant see: Using the Manual Bed Levelling Assistant