Tronxy X5s with Duet 2 WiFi & BLTouch & 2 Extruders
Feedback.. my Problem was… a wrong Z-Probe..
It doesn´t get the right timing an Result at the Probingpoint.
Maybe the trigger is too short or so.
A brand new Z-Probe and origin works fine.
The testing fails at my printer:
Hold a suitable surface below the print head to trigger the Z probe. The probe should trigger and the Z movement should stop.
If the Z movement doesn't stop, turn off power to the printer before the head crashes into the bed.
And whats is wenn Bed not Stop as ecpected??
Thats my problem. I read a lot about this problem..
-check/change cabeling (no positiv effect) all wiring as it should.
-check the config.g, the macros ond so on.. all, as it should be… hmm..
What the next Step???
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.