Is there no script to run to convert 2.x settings to 3.x settings? The problem with the instructions above is that it doesn’t identify which gcode to change in which files. Question: Can I run the 2.x configuration utility alongside a 3.x configuration utility and just create a 3.x configuration that way - to mimic my 2.x, and then apply the 3.x configuration to a freshly installed 3.0 firmware?
Endstop configuration still confusing. My switches are two wire, and connected as normally closed. The pins I connect to are GND and STOP. The endstop type is Active low (NC Switch). The LEDs are lit. But the status comes back as TRIGGERED.
Shouldn’t there be a configuration setting called “Active high (NC Switch)”? In any case, I need to know if I should use the VIN and STOP pins instead or change the configuration, or??
My SSID has an apostrophe in it. I had to double the apostrophe to quote it and now it works.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.