Web interface loaded, clicked “connect” button… won’t do anything.
@blindmoe Is/should it be possible to set the Z to move up to a known full step height, to save the accuracy for when it lowers again? I’m assuming it saves the Z print height then the Z stop height.
If a power failure occurs when the Z’s are on a micro step, then moves up say 5mm, it may remain on a micro step, but if it moves to say [FullStepHeight] if [FullStepHeight-ZPrintHeight >= 5] then we have a better guarantee of positional accuracy upon resume.
Just spitballing, I don’t know if this is implemented already or what the current situation is.
EDIT: Checked and its actually 5V. Looking into whether it’s easy enough to run it at 3V3.
Support for Prusa MK3 and MK3S filament sensors? They just have VCC, SIG and GND and operate at 3.3V. I’m assuming they could be a direct swap-in for the Duet laser sensor?
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.