I have the same bed size they describe in the doc, so I'm thinking I'll just copy/paste into my config.g and bed.g files. My question is, where should they go in the file? Should I put them at the top of the "Drive" section?
; Drives M569 P0 S0 ; Physical drive 0 goes Backwards
M569 P1 S0 ; Physical drive 1 goes Backwards
M569 P2 S1 ; Physical drive 2 goes forwards
M569 P3 S0 ; Physical drive 3 goes Backwards
M350 X16 Y16 Z16 E16 I1 ; Configure microstepping with interpolation
M92 X99.9 Y100.1 Z399.6183 E100 ; Set steps per mm
M566 X900.00 Y900.00 Z12.00 E120.00 ; Set maximum instantaneous speed changes (mm/min)
M203 X6000.00 Y6000.00 Z4000.00 E1200.00 ;
M201 X500.00 Y500.00 Z20.00 E250.00 ;
M906 X1100.00 Y1100.00 Z1100.00 E1100.00 I30 ;
M84 S30 ;
Set idle timeout Same question for the bed.g file.. Thank you! I'm rather hopeful this will solve the extrusion issue and get to printing.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.