I am seeing the “temperature rising much more slowly than the expected 1.4C/sec” fault, because the rate of temperature rise of the hot end is marginally slower when the printer’s heated bed is on (input voltage drops to about 11.3V rather than 12.0V) and the PID tuning was done with the heated bed off.
Presumably if I retune the PIS parameters with the heated bed on, this should solve this problem or will I run into a “temperature rising much more rapidly than the expected x.xC/sec” fault?
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.