Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Editing Step 8 —

Step Type:

Drag to rearrange

It is important that you check that the Duet is receiving a signal from your endstops. Failure to do so could cause damage to your printer!

You can see the live status of your endstops in the Machine Properties section of the web interface. Here's how to access it:

Navigate to "Settings"

Click the "Machine Properties" tab.

"Endstop Hit" shows an instantaneous status of each endstop.

The default endstop mapping is: X=0, Y=1 and Z=2.

The endstop status displayed might not be correct. If it is wrong, we will fix this in configuration.

Your contributions are licensed under the open source Creative Commons license.