Editing Step 4 —

Step Type:

Drag to rearrange

The General Tab is used to define a few basic starting values like which board you are using, whether to use resume on power loss functionality, the size of your build volume, and what kinematics your printer uses.

Make the following changes:

Select Duet 3 Mini 5 + (Ethernet) or (Wifi) depending on your version of the board.

Give your printer a name.

Check Run in standalone mode without SBC. (That will come later)

Check read config-override.g

Check save print state on power failure and set the threshold values for power save as 21v and 23v

Maximum travel distance is X235 Y235 Z260

Your contributions are licensed under the open source Creative Commons license.