I've used pieces of electrical tape to bind the wires together into a bundle to make them easier to feed into the nylon wrap.
I've used velcro wrap to affix the new wiring loom to the existing hotend loom.
At the Duet end, connect the BLTouch Molex KK plug to the io_3 port.
The order of the pins on the io_3 port is a bit different than on the Duet Maestro Z Probe port, so the order of the wires will need to match, and will be shown next.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.