The BLTouch has 5 wires which need to be extended to the Duet board. (Technically 4 if you only extend a single ground.)
You'll need 5 lengths of wire approximately 1 meter in length. You'll need some Dupont connectors and crimps, a crimper, wire stripper, and wire cutter. You'll also need the 5 pin Molex plug connector from the Duet connector package for the Z probe port.
A length of nylon loom can help protect the wires and match the look of the stock hotend wiring loom.
In our loom we will include an additional 2 lengths of wire to be used for a small LED strip. These two wires will be piggybacked onto the 2 wires from the LED strip used for the top frame.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.