Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Editing Step 28 —

Step Type:

Drag to rearrange

Once you’ve got everything wired up you can reinstall the case onto the frame.

Or if you did like me and left the case on the frame and wired everything up in place, now is a good time to route the cables and do some strain relief.

You may find it easier to disconnect some wires temporarily and reconnect them once it’s installed. It’s a tight fit, but it will all fit. I suggest leaving the 2 screws on the front loose and align and tighten the screw directly under the bed first.

For the VIN and bed wires you will need to bend the spade connector upwards to fit back onto the frame.

Once you’ve got all your wires reconnected, you can use some zip ties, etc., to provide some strain relief for the bundle leaving the case.

Your contributions are licensed under the open source Creative Commons license.