Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Editing Step 9 —

Step Type:

Drag to rearrange

Next, we will re-terminate the wires using the provided crimp connectors. How you connect the wires to the board is up to you, but in this case, we will be snipping off the existing connector, stripping the ends, and re-crimping a new connector that fits the Mini 5+ specifically.

The only exception is the motor plugs, which we will modify slightly so they can plug into the Mini 5+ as is. Pay close attention to the orientation of the Creality plugs and the markings on the Creality board in order to preserve polarity of the connectors.

Take out and sort the connector ends that came with the Mini 5+. You’ll need a crimping tool.

It can also be helpful to use the wiring diagram and details found here to help guide you.

Your contributions are licensed under the open source Creative Commons license.