Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 6 —

Step Type:

Drag to rearrange

For Duet 2 WiFi:

The WiFi module has a blue LED on it, just next to the Micro SD card holder. This should flash once when power is connected to the board, but will only be lit permanently if it is connected to a WiFi network. Duets with an external antenna use a different WiFi module, with no indicator LED.

You may find you are getting a lot of messages like "WiFi reported error: no known networks found". The default configuration turns on the WiFi, but it is not finding a network to connect to. To stop the WiFi, send M552 S-1.

Send M552 to check the status. It should say "WiFi module is disabled". Now put it into idle mode by sending command M552 S0. Send M552 again to check it's in idle, then proceed to the next step.

For Duet 2 Ethernet and Duet 2 Maestro:

Send M552 to check the network module status.

It may report that the module is disabled or enabled. Put it into disabled mode by sending command M552 S0. Send M552 again to check it is disabled, then proceed to the next step.

Your contributions are licensed under the open source Creative Commons license.