Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Step Type:

Drag to rearrange

The Duet 2 Ethernet / Maestro come with a factory-configured fixed IP address for testing. In the last few steps you set up network access temporarily. For these Duets, and for Duet 3 with Ethernet in standalone mode, you now need to change the config.g so you can access the Duet Web Console (DWC) following a power cycle.


Most home routers are setup to assign IP addresses by DHCP. Change the M552 P192.168.1.14 line in config.g to M552 P0.0.0.0 to have your router assign an IP address via DHCP. This is standard for most network devices. Any other network settings are set automatically.

If you are not familiar with networking, you should change this setting to M552 P0.0.0.0

For Fixed IP address:

You can set the Duet to use a fixed IP address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network. Change the M552 P192.168.1.14 line to the IP address you want to use, eg M552 P192.168.0.15

You may also need to change the M554 (Gateway) and M553 (Netmask) commands to match your network.

Your contributions are licensed under the open source Creative Commons license.