DHCP.If you have setup the Duet 2 Ethernet to use DHCP then when the network is enabled it will look for a DHCP server to allocate an address. Most home routers are setup to assign addresses by DHCP.
Send the command "M552 S1" to the board.
After about 30 seconds, the board should reply with Network running and the IP address that the Duet has been assigned.
Fixed Address If you have used a fixed IP address in config.g then when the network is enabled the Duet 2 Ethernet will use that address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network.
The Duet 2 Ethernet and Duet 2 Maestro come with a factory configured fixed address used during testing. This address will probably not work with your network and may cause conflicts. It is recommended to enable DHCP when using the RepRapFirmware configuratorto generate your configuration file.
Mac users: Press CRTL-A and then CRTL-D to exit screen and return to terminal. You can safely close Terminal at this point.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.