Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at https://docs.duet3d.com/
Help
/

Site Navigation

Your Account

Choose Language

Editing Step 22 —

Step Type:

Drag to rearrange

The order of the BLTouch wires at the Duet end require that the two ground wires are connected to the same pin. This is the black and brown wire in the photo and matches the color of the BLTouch wiring.

I used the same technique as described in the LED wiring for the hotend. A single wire is crimped to the pin, and the second wire is soldered carefully onto the pin.

Note the 2 wires going into the one pin between the yellow and white wires. A piece of electrical tape was used to act as strain relief.

Your contributions are licensed under the open source Creative Commons license.