Next, we will verify that the end stops are triggering properly.
Go to the Settings > Machine properties > find the column that shows End stop hit.
X, Y, and Z end stops should say "No", E should say "Yes"
Manually trigger the end stops with your finger, you should see the value change to "Yes" for each one you press.
If the values do not change, power down the printer and double check your wiring connections.
If the values for X, Y, and Z show "Yes" by default, and "No" when triggered, you chose the wrong switch type in the configurator.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.