Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at https://docs.duet3d.com/
Help
Editing Step 9 —

Step Type:

Drag to rearrange

This tab defines the area of the bed to be probed when using Mesh Compensation.

Typically this is used with a Z Probe, but it can actually be done manually as well.

Even though the stock Ender 3 doesn't have a Z probe, we will define the probe area anyway just in case you add a probe in the future.

Set the area to be X min 10, X max 220, Y min 10, Y max 220, with a spacing of 20mm.

See this guide for further information on using mesh bed compensation:

Your contributions are licensed under the open source Creative Commons license.