This tab defines the area of the bed to be probed when using Mesh Compensation.
Typically this is used with a Z Probe, but it can actually be done manually as well.
Even though the stock Ender 3 doesn't have a Z probe, we will define the probe area anyway just in case you add a probe in the future.
Set the area to be X min 10, X max 220, Y min 10, Y max 220, with a spacing of 20mm.
See this guide for further information on using mesh bed compensation:
Mesh bed compensation
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.