The Endstops Tab defines what type of endstop switch is being used (NO/NC), and where on the printer its located (Low End/High End).
It also defines the Z Probe. The stock Ender 3 does not come with a Z probe by default. A future guide will go through adding one.
The Ender 3 Pro uses Active high (NC) switches and trigger at the low end of travel (X0, Y0, Z0)
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.