The end stop connectors will need to be redone. The Creality end stop switches have only two wires for signal and ground, but the Maestro end stop connectors have 3 wires: signal, ground and 3.3v power.
We will use the 3 wide connector and place the wires in the outer two spots, leaving the center unpopulated. The order of the two wires does not matter, so long as they are connected to the outside pins only.
Further information on connecting end stops can be found here on the wiki.
Connecting endstop switches
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.