Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Editing Step 13 —

Step Type:

Drag to rearrange

Before conducting this step, temporarily alow axis movement without homing by navigating to the G Code console and entering: M564 S0 H0

Navigate back to the Machine Control page. At this time, we will check the operation of our stepper motors.

Move each stepper motor, individually, 1 mm in each direction. If any motors are incorrect, we will fix them in the next step.

Note that a stepper can't be moved before homing. unless the M564 command is used to override this safety default.

If your motor moves in the correct direction, you may home the axis at this time.

Important: Be sure that you have confirmed the correct operation of your endstops before homing.

Your contributions are licensed under the open source Creative Commons license.