Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Step Type:

Drag to rearrange

Remaining in the same config.g file as the last step, observe the number next to each axis' endstop - for example X0, Z0 and Y2.

Think of "low end" and "high end" as a numeric scale for the axis. If your Y axis has a 250mm range of motion, the low end is 0mm and the high end is 250mm.

Observe the physical location of each endstop and compare it to this setting. If it is incorrect, change it now.

Your contributions are licensed under the open source Creative Commons license.