Remaining in the same config.g file as the last step, observe the number next to each axis' endstop - for example X0, Z0 and Y2.
Think of "low end" and "high end" as a numeric scale for the axis. If your Y axis has a 250mm range of motion, the low end is 0mm and the high end is 250mm.
Observe the physical location of each endstop and compare it to this setting. If it is incorrect, change it now.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.