Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at https://docs.duet3d.com/

Changes to Step #13

Edit by Filastruder

Edit approved by Filastruder

Before
After
Unchanged

Step Lines

+[title] Bed Heater
+[* icon_note] The Duet is able to power a heated bed up to 18A. This should be well above the requirement for most heated beds.
+[* black] It is recommended to use the included ferrules, by crimping them to the wires before putting the wires in there terminal block.
+[* black] Do not tin (add solder to) these wires.
+[* black] Be sure not to twist the terminal block while tightening the screws. It can help to hold the terminal block while tightening.
+[* black] Check the screws after a few days/week of operation to ensure they are still snug.

Image 1

No previous image

Added