Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Filastruder

Edit approved by Filastruder

Deleted
Added
Unchanged

Step Lines

[title] Hotend Heaters
[* blackyellow] Your hotend heaters willshould be connected here. From left to right, the connectors are E1 and E0.
[* icon_note] Polarity does not mattermatter for hotend heaters.
[* black]icon_caution] WARNING: It is HIGHLY recommended to use the included ferrules, by crimping them to the wires before putting the wires in the terminal block. Failure to do so could allow the wires to creep over time, become loose, and could possibly short circuit and start a fire.
[* blackyellow] Your hotend heaters willshould be connected here. From left to right, the connectors are E1 and E0.
[* icon_note] Polarity does not mattermatter for hotend heaters.
[* black]icon_caution] WARNING: It is HIGHLY recommended to use the included ferrules, by crimping them to the wires before putting the wires in the terminal block. Failure to do so could allow the wires to creep over time, become loose, and could possibly short circuit and start a fire.
[* black] Do not tin (add solder to) these wires.
[* black] Be sure not to twist the terminal block while tightening the screws. It can help to hold the terminal block while tightening.
[* black] Check the screws after a few days/week of operation to ensure they are still snug.

Image 1

Old Version

New Version