Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at https://docs.duet3d.com/

Changes to Step #8

Edit by Tony

Edit approved by Tony

Before
After
Unchanged

Step Lines

-[title] Checking Enstops
+[title] Checking Endstops
[* icon_caution] It is important that you check that the Duet is receiving a signal from your endstops. Failure to do so could cause damage to your printer!
[* black] Check your endstops by issuing a M119 command via the Duet's web interface G-Code Console.
[* icon_note] The status indicated by M119 does not necessarily indicate if the endstop is engaged or not. If they appear to be incorrect, we will resolve this later on in ***configuration***.