https://docs.duet3d.com/

Changes to Step #5

Edit by Jason Znack

Edit approved by Jason Znack

Before
After
Unchanged

Step Lines

[title] I/O Mapping Tab
-[* black] Here we will define the pins used for our drivers, endstops, heaters, fans, probe, etc.
-[* black] X Endstop = io1.in, Y Endstop = io1.in, Z Endstop = io2.in.
+[* black] Here we will define the pins used for our drivers, endstops, heaters, fans, probe, etc. Refer to the table of pin assignments from Part 1.
+[* black] X as Driver_0, Y as Driver_1, Z as Driver_2, E as Driver_3
+[* black] X Endstop = io5.in, Y Endstop = io6.in, Z Endstop = io2.in.
[* black] Heater0 (bed) = OUT0 and TEMP0. Heater1 (hotend) = OUT1 and TEMP1.
-[* black] Fan0 = out3, Fan1 = Out4, Fan2 = Out5, Fan3 = VFD (Out6) for the LED strip.
-[* black] Z-Probe will be a BLTouch, so for Inout Pin choose io3.in, leave Modulation Pin unassigned, and PWM Control Channel as io4.out. This will be changed to io3.out manually later.
+[* black] Fan0 = out3, Fan1 = Out4, Fan2 = Out5, Fan3 = Out6 for the LED strip.
+[* black] Z-Probe will be a BLTouch, so for Input Pin choose io3.in, leave Modulation Pin unassigned, and PWM Control Channel as io3.out.

Image 1

No previous image

Added

Image 2

No previous image

Added