https://docs.duet3d.com/

Changes to Step #4

Edit by Jason Znack

Edit approved by Jason Znack

Before
After
Unchanged

Step Lines

+[title] General Tab
+[* black] The General Tab is used to define a few basic starting values like which board you are using, whether to use resume on power loss functionality, the size of your build volume, and what kinematics your printer uses.
+[* black] Make the following changes:
+ [* black] Select Duet 3 Mini 5 + (Ethernet) or (Wifi) depending on your version of the board.
+ [* black] Give your printer a name.
+ [* black] Check Run in standalone mode without SBC. (That will come later)
+ [* black] Check read config-override.g
+ [* black] Check save print state on power failure and set the threshold values for power save as 21v and 23v
+ [* black] Maximum travel distance is X235 Y235 Z260