Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by Jason Znack

Edit approved by Jason Znack


Step Lines

+[title] Disassembly
+[* black] First, we need to take the old Creality board out. Disconnect and remove the display from the frame. Then disconnect the Z end stop wire from the end stop. This will make the next steps easier. Now remove the screws holding the electronics enclosure together. Two on the front, two on top, and 3 underneath.
+[* black] Once the electronics enclosure is loose, you can take the base off and expose the board. Remove the 4 screws holding down the board to the plate. Set all the screws aside where you won’t lose them.